【ACU15EG】Core board, XCZU15EG industrial grade
Update time：2021-08-25 Pageviews：685
ACU15EG (core board model, the same below) core board, ZYNQ chip is based on XILINX's Zynq UltraScale+MPSoCs EG series XCZU15EG-2FFVB1156I. This core board uses 6 Micron DDR4 chips MT40A512M16GE, of which 4 DDR4 chips are mounted on the PS side to form a 64-bit data bus bandwidth and 4GB capacity. PL end mounts 2 slices, it is 32-bit data bus width and 2GB capacity.
The DDR4 SDRAM on the PS side can run at a maximum speed of 1200MHz (data rate 2400Mbps), and the DDR4 SDRAM on the PL side can run at a maximum speed of 1200MHz (data rate 2400Mbps). In addition, the core board also integrates two 256MBit size QSPI FLASH and 8GB size eMMC FLASH chips, used to start storage configuration and system files.
The development board uses Xilinx's Zynq UltraScale+ MPSoCs EG series of chips, the model is XCZU15EG-2FFVB1156I. The PS system of the ZU15EG chip integrates 4 ARM Cortex™-A53 processors with a speed of up to 1.3Ghz and supports Level 2 Cache; in addition, ZU15EG also contains 2 Cortex-R5 processors.
The DDR4 SDRAM on the PS side can run at a maximum speed of 1200MHz (data rate 2400Mbps), and the DDR4 SDRAM on the PL side can run at a maximum speed of 1200MHz (data rate 2400Mbps). In addition, the core board also integrates two 256MBit size QSPI FLASH and 8GB size eMMC FLASH chips, used to start storage configuration and system files.
The development board uses Xilinx's Zynq UltraScale+ MPSoCs EG series of chips, the model is XCZU15EG-2FFVB1156I. The PS system of the ZU15EG chip integrates 4 ARM Cortex™-A53 processors with a speed of up to 1.3Ghz and supports Level 2 Cache; in addition, ZU15EG also contains 2 Cortex-R5 processors.
Static storage interface, support NAND, 2xQuad-SPI FLASH.
High-speed connection interface, supports PCIe Gen2 x4, 2xUSB3.0, Sata 3.1, DisplayPort, 4x Tri-mode Gigabit Ethernet.
Common connection interfaces: 2xUSB2.0, 2x SD/SDIO, 2x UART, 2x CAN 2.0B, 2x I2C, 2x SPI, 4x32b GPIO.
Power source management: supports the division of Full/Low/PL/Battery four parts of power.
Encryption algorithm: support RSA, AES and SHA. -System monitoring: 10-bit 1Mbps AD sampling for temperature and voltage detection.
High-speed connection interface, supports PCIe Gen2 x4, 2xUSB3.0, Sata 3.1, DisplayPort, 4x Tri-mode Gigabit Ethernet.
Common connection interfaces: 2xUSB2.0, 2x SD/SDIO, 2x UART, 2x CAN 2.0B, 2x I2C, 2x SPI, 4x32b GPIO.
Power source management: supports the division of Full/Low/PL/Battery four parts of power.
Encryption algorithm: support RSA, AES and SHA. -System monitoring: 10-bit 1Mbps AD sampling for temperature and voltage detection.
